eLibrary >
BS EN ISO 16808:2014 Metallic materials. Sheet and strip. Determination of biaxial stress-strain curve by means of bulge test with optical measuring systems >
Expand All
TOC Search:
BS EN ISO 16808:2014 Metallic materials. Sheet and strip. Determination of biaxial stress-strain curve by means of bulge test with optical measuring systems, 2014
- Foreword
- Section sec_1
- Section sec_2
- Table tab_1
- Section sec_3
- Table tab_a
- Figure fig_1
- Section sec_4
- Section sec_4.1
- Table tab_b
- Figure fig_2
- Section sec_4.2
- Section sec_4.3
- Section sec_4.4
- Section sec_4.5
- Section sec_4.6
- Section sec_4.7
- Section sec_4.8
- Section sec_4.9
- Table tab_c
- Figure fig_3
- Section sec_5
- Section sec_6
- Section sec_6.1
- Section sec_6.2
- Section sec_6.2.1
- Section sec_6.2.2
- Section sec_7
- Section sec_7.1
- Section sec_7.2
- Section sec_7.3
- Section sec_7.4
- Section sec_7.5
- Section sec_7.6
- Section sec_7.7
- Section sec_7.8
- Section sec_7.9
- Section sec_8
- Figure fig_4
- Section sec_9
- Section sec_10
- Annex sec_A
- Annex sec_B
- Annex sec_B.1
- Table tab_e
- Figure fig_B.1
- Annex sec_B.2
- Table tab_f
- Figure fig_B.2
- Table tab_g
- Figure fig_B.3
- Annex sec_B.3
- Table tab_h
- Figure fig_B.4
- Annex sec_C
- Annex sec_C.1
- Annex sec_C.2
- Annex sec_D
- Annex sec_D.1
- Annex sec_D.2
- Table tab_i
- Figure fig_D.1
- Table tab_D.1
- Table tab_D.2
- Reference ref_1
- Reference ref_2
- Reference ref_3
- Reference ref_4
- Reference ref_5
- Reference ref_6
- Reference ref_7
- Reference ref_8
- Reference ref_9
- Reference ref_10
- Reference ref_11
- Reference ref_12
- Reference ref_13
- Foreword
- 1 Scope
- 2 Symbols and abbreviated terms
- 3 Principle
- 4 Test equipment
- 5 Optical measurement system
- 6 Test piece
- 6.1 General
- 6.2 Application of grid
- 7 Procedure
- 8 Evaluation methods for the determination of the curvature and strains at the pole
- 9 Calculation of biaxial stress-strain curves
- 10 Test report
- Annex A (informative) International comparison of symbols used in the determination of the bulge test flow curve
- Annex B (normative) Test procedure for a quality check of the optical measurement system
- Annex C (informative) Computation of the curvature on the basis of a response surface
- Annex D (informative) Determination of the equi-biaxial stress point of the yield locus and the hardening curve
- Bibliography [Go to Page]