ASTM D747-08
Historical Standard: ASTM D747-08 Standard Test Method for Apparent Bending Modulus of Plastics by Means of a Cantilever Beam
SUPERSEDED (see Active link, below)
ASTM D747
1. Scope
1.1 This test method covers the determination of the apparent bending modulus of plastics by means of a cantilever beam. It is well suited for determining relative flexibility of materials over a wide range. It is particularly useful for materials too flexible to be tested by Test Methods D 790 .
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1There is no known ISO equivalent to this standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D618 Practice for Conditioning Plastics for Testing
D790 Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials
D4000 Classification System for Specifying Plastic Materials
D5947 Test Methods for Physical Dimensions of Solid Plastics Specimens
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Keywords
apparent bending modulus; bending movement; cantilever beam; stiffness; Apparent bending modulus; Cantilever testing; Deformation--plastics; Bending moment; Flexibility--plastics; Stiffness--plastics;
ICS Code
ICS Number Code 83.080.01 (Plastics in general)
DOI: 10.1520/D0747-08
ASTM International is a member of CrossRef.