eLibrary >
BS EN ISO 12215-5:2019 Small craft. Hull construction and scantlings - Design pressures for monohulls, design stresses, scantlings determination >
Expand All
TOC Search:
BS EN ISO 12215-5:2019 Small craft. Hull construction and scantlings - Design pressures for monohulls, design stresses, scantlings determination, 2023
- undefined
- 5.1 Materials
- 5.2 Overall procedure for scantlings determination
- 6.1 Dimensions and data
- 6.2 Areas [Go to Page]
- 7.1 General
- 7.2 Rectangular grid of panels and stiffeners
- 7.3 Non-rectangular panels [Go to Page]
- 7.4 Pressure on a panel or a stiffener
- 8.1 General
- 8.2 Design category factor kDC
- 8.3 Dynamic load factor kDYN
- 8.4 Longitudinal pressure distribution factor kL
- 8.5 Area pressure reduction factor kAR
- 8.6 Superstructures and deckhouse pressure reduction factor kSUP
- 8.7 Pressure correcting factor kSLS for slamming of light and stable sailing craft
- 9.1 Design pressure for motor craft
- 9.2 Design pressure for sailing craft
- 9.3 Watertight bulkheads and integral tank boundaries design pressure [Go to Page]
- 10.1 Boat building quality factor kBB
- 10.2 Assessment method factor kAM
- 10.3 Design stresses according to material and calculation method
- 11.1 The six available methods
- 11.2 Method 1: "Simplified" method
- 11.3 Method 2: "Enhanced" method (ply by ply analysis)
- 11.4 Method 3: "Developed" method for any laminate, including non-balanced laminates
- 11.5 Method 4: "Direct test method"
- 11.6 Method 5: "FEM" Finite Element Method [Go to Page]
- 11.7 Method 6: Alternative test: Drop test
- 11.8 "Good practice" minimal thickness
- 13.1 General
- 13.2 Normal mode of operation
- 13.3 Information to take care of sandwich plating
- 13.4 Information required by Annex J for commercial craft and workboats [Go to Page]
