ASTM A1010/A1010M-01e1
Historical Standard: ASTM A1010/A1010M-01e1 Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet , and Strip
SUPERSEDED (see Active link, below)
ASTM A1010 / A1010M
1. Scope
1.1 This specification covers martensitic stainless steels for various structural, architectural, pressure vessel, and heat-resisting applications. The mechanical properties of these steels are customarily, but not necessarily, developed by a suitable heat treatment generally referred to as tempering.
1.2 Steel products under this specification are available in two grades:
| Grade | Yield Strength, min, ksi (MPa) |
| 40 (275) | 40 (275) |
| 50 (350) | 50 (350) |
1.3 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements; however, current practice normally limits the maximum thickness of plates furnished under this specification to 1 in. (25 mm).
1.4 The values stated in inch-pound or SI units are to be regarded separately as the standard. Within the text, SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the 'M' designation of this specification is specified in the purchase order.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A480/A480M Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
A673/A673M Specification for Sampling Procedure for Impact Testing of Structural Steel
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
Other Document
SAEJ1086 Recommended Practice for Numbering Metals and Alloys Available from Society of Automotive Engineers (SAE), 400 Commonwealth Dr., Warrendale, PA 15096-0001, http://www.sae.org.Keywords
architectural steel; martensitic; plate; stainless steel; steel; structural steel; tempered; Architectural steel; Martensitic stainless steel plate/sheet/strip--specifications; Stainless steel plate/sheet/strip--specifications; Steel plate--specifications; Structural steel (SS) plate--specifications; Tempered structural steel--specifications ;
ICS Code
ICS Number Code 77.140.01 (Iron and steel products in general)
DOI: 10.1520/A1010_A1010M-01E01
ASTM International is a member of CrossRef.
