Abstract
This specification deals with compacted graphite iron castings. These materials shall be examined metallographically for the acceptance graphite formation. The acceptable graphite formation in the microstructure of the test coupon or casting lug shall contain 80% minimum Type IV graphite. The iron shall conform to the requirements for tensile properties: tensile strength, yield strength, and elongation. Test bars and test coupons shall be cast in dried, baked, or chemically bonded molds consisting of an aggregate of silica sand with appropriate bonders and shall be subjected to the same thermal treatment as the castings they represent.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers castings made of compacted graphite iron, which is described as cast iron with the graphite in compacted (vermiform) shapes and essentially free of flake graphite in the bulk of the casting.
1.2 No precise quantitative relationship can be stated between the properties of iron in the various locations of the same casting and those of a test bar cast from the same iron (see Appendix X1).
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3.1 Exception The inch-pound units in Figs. 1-3 and 5 are standard. SI units are added for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A247 Test Method for Evaluating the Microstructure of Graphite in Iron Castings
E8/E8M Test Methods for Tension Testing of Metallic Materials
Federal Standard
FederalStandardNo.12 Marking for Shipment (Civil Agencies) American National Standard
MIL-STD-129 Marking for Shipment and Storage
Keywords
Cast iron--specifications; Compacted graphite iron castings; Graphite--specifications; Graphite iron castings ;
ICS Code
ICS Number Code 77.080.10 (Irons); 77.140.80 (Iron and steel castings)
DOI: 10.1520/A0842-11A
ASTM International is a member of CrossRef.
ASTM A842