ASTM A962/A962M
Scope
1.1 This specification covers a group of common requirements that shall apply to carbon, alloy, stainless steel, and nickel alloy bolting under any of the
following ASTM Specifications (or under any other ASTM Specifications that invoke this specification or portions thereof):
Title of Specifications
|
ASTM Designation
|
Alloy-Steel and Stainless Steel Bolting for
High Temperature or High Pressure Service and
Other Special Purpose Applications
|
A193/A193M
|
Carbon Steel, Alloy Steel, and Stainless Steel Nuts
for Bolts for High Pressure or High Temperature
Service, or Both
|
A194/A194M
|
Alloy-Steel and Stainless Steel Bolting for Low-
Temperature Service
|
A320/A320M
|
Stainless and Alloy-Steel Turbine-Type Bolting
Specially Heat Treated for High-Temperature
Service
|
A437/A437M
|
High-Temperature Bolting, with Expansion
Coefficients Comparable to Austenitic Stainless
Steels
|
A453/A453M
|
Alloy-Steel Bolting for Special Applications
|
A540/A540M
|
Precipitation-Hardening Bolting (UNS N07718)
for High Temperature Service
|
A1014/A1014M
|
High Strength Precipitation Hardening and Duplex
Stainless Steel Bolting for Special Purpose
Applications
|
A1082/A1082M
|
1.2 In case of conflict, the requirements of the individual product specification shall prevail over those of this specification.
1.3 Fasteners are a wide-ranging classification that includes screws, bolts, nuts, washers, stud bolts, rivets, powder-actuated studs, staples, tacks, and
pins. Bolting, which is composed of bolting materials, such as rods, bars, flats, and forgings, which are subsequently manufactured into bolting components, are a special sub-group of
fasteners. Bolting materials and components have designated compositions and specific properties intended for applications in aggressive service where commercial generic fasteners may not be
suitable or have insufficient fitness for purpose under certain conditions. These conditions include cryogenic or high temperature service, or excessive vibration, impact, or shock. To further
address any other special service conditions where bolting is intended for use, additional requirements may be specified by mutual agreement between the purchaser and supplier.
1.4 Supplementary requirements are provided for use at the option of the purchaser. The supplementary requirements only apply when specified individually
by the purchaser in the purchase order or contract.
1.5 This specification is expressed in both inch-pound units and in SI units. Unless the purchase order or contract specifies the applicable “M”
specification designation (SI units) the inch-pound units shall apply. The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the
SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two
systems may result in nonconformance with the specification.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on
Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
austenitic stainless steel; bolts, steel; bolting components, steel; bolting materials; components, steel; nickel alloy bolting; nuts, steel; pressure vessel service; screws; stainless steel
bolting; steel bars, alloy; steel bars, carbon; steel bars, stainless; steel bolting; studs; temperature service applications, high; temperature service applications, low; turbine materials;
washers;
ICS Code
ICS Number Code 21.060.01 (Fasteners in general)
DOI: 10.1520/A0962_A0962M-23A