ASTM B212-09
Historical Standard: ASTM B212-09 Standard Test Method for Apparent Density of Free-Flowing Metal Powders Using the Hall Flowmeter Funnel
SUPERSEDED (see Active link, below)
ASTM B212
1. Scope
1.1 This test method describes a procedure for determining the apparent density of free-flowing metal powders, and mixed powders; and is suitable for only those powders that will flow unaided through the specified Hall Flowmeter funnel.
1.2 With the exception of density values, for which the g/cm 3 unit is the industry standard, the values stated in SI units are to be regarded as the standard. Values in inch-pound units are shown in parentheses and result from conversion in accordance with IEEE/ASTM Standard SI 10. They may be approximate and are only for information.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B215 Practices for Sampling Metal Powders
B243 Terminology of Powder Metallurgy
B873 Test Method for Measuring Volume of Apparent Density Cup Used in Test Methods B 212, B 329, and B 417
Keywords
apparent density; Hall flowmeter funnel; metal powders;
ICS Code
ICS Number Code 77.160 (Powder metallurgy)
DOI: 10.1520/B0212-09
ASTM International is a member of CrossRef.
