1. Scope

1.1 This specification covers the requirements for rod drawing stock in diameters from 1/4 to 13/8 in. (6.4 to 35 mm) produced from electrolytic tough-pitch or oxygen-free coppers and are suitable for further fabrication into electrical conductors.

1.2 The values stated in inch-pound units are the standard. The values given in parentheses are for information only.

1.3 The following safety hazards caveat pertains only to Section 13. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

B5 Specification for High Conductivity Tough-Pitch Copper Refinery Shapes

B115 Specification for Electrolytic Copper Cathode

B170 Specification for Oxygen-Free Electrolytic Copper--Refinery Shapes

B193 Test Method for Resistivity of Electrical Conductor Materials

B224 Classification of Coppers

B577 Test Methods for Detection of Cuprous Oxide (Hydrogen Embrittlement Susceptibility) in Copper

B846 Terminology for Copper and Copper Alloys

E8 Test Methods for Tension Testing of Metallic Materials

E18 Test Methods for Rockwell Hardness of Metallic Materials

E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E53 Test Method for Determination of Copper in Unalloyed Copper by Gravimetry

E478 Test Methods for Chemical Analysis of Copper Alloys

E1606 Practice for Electromagnetic (Eddy-Current) Examination of Copper Redraw Rod for Electrical Purposes

E2575 Test Method for Determination of Oxygen in Copper and Copper Alloys

Other Document

Keywords

cathode; copper redraw rod; electrical conductors; oxygen-free copper; shaving; tough-pitch copper: UNS C11000 (electrolytic tough pitch coper (ETP)); AACSR (aluminum-alloy conductors, steel reinforced); Copper electrical conductors--specifications; Copper rod/bar/shapes--specifications; Redraw rod; UNS C11040; UNS C10100 (oxygen-free copper); UNS C10200 (oxygen-free copper (OF)) ;

ICS Code

ICS Number Code 29.050 (Superconductivity and conducting materials)

DOI: 10.1520/B0049-98E02

ASTM International is a member of CrossRef.