Abstract

This specification covers UNS N06625, N06219, and N08825 nickel-alloy welded pipe in the annealed condition. The pipe shall be manufactured from flat-rolled alloy by an automatic welding process with no additional filler metal. The pipe material shall be cold-worked, annealed, and nondestructively tested. The pipe shall be furnished with oxide removed. The material shall conform to the composition required by the specification. The pipe shall be subjected to tensile, yield, elongation, transverse guided bend, and nondestructive test requirements. Nondestructive test includes hydrostatic, pneumatic, eddy current, ultrasonic, leak, and electric testing. Acceptable size limit of cracks or other defect after bending test is specified.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers welded UNS N06625,* UNS N06219* and UNS N08825* pipe in the annealed condition (temper) for general corrosion applications.

1.2 This specification covers pipe sizes in schedules shown in the Permissible Variations in Outside Diameter and Wall Thickness for Welded Pipe table of Specification B 775 .

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following precautionary caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

B751 Specification for General Requirements for Nickel and Nickel Alloy Welded Tube

B775 Specification for General Requirements for Nickel and Nickel Alloy Welded Pipe

B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys

ASME Boiler and Pressure Vessel Code

Keywords

N06219; N06625; N08825; welded pipe; Corrosive service applications--pipe (Ni/Ni alloy); Nickel alloy pipe--specifications; Nickel-chromium alloys--specifications; Nickel-chromium-molybdenum-columbium alloys--specifications; Nickel-iron-chromium alloys--specifications; Nicrofer 6219Si; Udimet alloy; UNS N06219 (Ni-Cr-Mo-Si alloy, Nicrofer 6219Si); UNS N06625 (Ni-Cr alloy, Inconel 625); UNS N08825 (Ni-Fe-Cr alloy, Incoloy 825); Welded Ni/Ni alloy pipe--specifications;

ICS Code

ICS Number Code 77.120.40 (Nickel, chromium and their alloys)

DOI: 10.1520/B0705-05R09

ASTM International is a member of CrossRef.

ASTM B705