1. Scope

1.1 This specification establishes the requirements for two wall thickness schedules of specially cleaned, straight lengths of seamless copper tube, identified as Types K and L, suitable for medical gas systems. The tube shall be installed in conformance with the requirements of the National Fire Protection Association (NFPA) Standard 99, Gas and Vacuum Systems (NFPA) Standard 99C, Standard for Hypobaric Facilities (NFPA) Standard 99B, and Canadian Standards Association (CSA) Standard Z 305.1/Z 7396.1, Nonflammable Medical Gas Piping Systems.

Types K and L tube are defined in Specification B 88.

Drawn temper tube is suitable for use with capillary (solder joint) fittings for brazing.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.

The following safety hazard caveat pertains only to the test method portion of Section of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

B88 Specification for Seamless Copper Water Tube

B251 Specification for General Requirements for Wrought Seamless Copper and Copper-Alloy Tube

B280 Specification for Seamless Copper Tube for Air Conditioning and Refrigeration Field Service

B601 Classification for Temper Designations for Copper and Copper Alloys--Wrought and Cast

B846 Terminology for Copper and Copper Alloys

E8 Test Methods for Tension Testing of Metallic Materials

E18 Test Methods for Rockwell Hardness of Metallic Materials

E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E53 Test Method for Determination of Copper in Unalloyed Copper by Gravimetry

E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)

E243 Practice for Electromagnetic (Eddy-Current) Examination of Copper and Copper-Alloy Tubes

E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)

Other Standards

Keywords

ACR medical gas tube; copper tube; seamless; MED medical gas tube; medical gas systems; OXY medical gas tube; Type K medical gas tube; Type L medical gas tube; ACR medical gas tube; Gases; MED medical gas tube; Oxygen service/systems; Seamless Cu/Cu alloy tube--specifications; Tube for medical gas systems; Type K/L medical gas tube; UNS C12200 (phosphorus deoxidized, high residual phosphorus copper (DHP))

ICS Code

ICS Number Code 11.040.10 (Anaesthetic, respiratory and reanimation equipment)

DOI: 10.1520/B0819-00R06

ASTM International is a member of CrossRef.