ASTM C1048-97b
Historical Standard: ASTM C1048-97b Standard Specification for Heat-Treated Flat Glass--Kind HS, Kind FT Coated and Uncoated Glass
SUPERSEDED (see Active link, below)
ASTM C1048
1. Scope
1.1 This specification covers the requirements for flat heat-strengthened and flat fully tempered coated and uncoated glass used in general building construction.
1.2 The dimensional values, except thickness designations, stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C162 Terminology of Glass and Glass Products
C346 Test Method for 45-deg Specular Gloss of Ceramic Materials
C724 Test Method for Acid Resistance of Ceramic Decorations on Architectural-Type Glass
C978 Test Method for Photoelastic Determination of Residual Stress in a Transparent Glass Matrix Using a Polarizing Microscope and Optical Retardation Compensation Procedures
C1036 Specification for Flat Glass
C1203 Test Method for Quantitative Determination of Alkali Resistance of a Ceramic-Glass Enamel
C1279 Test Method for Non-Destructive Photoelastic Measurement of Edge and Surface Stresses in Annealed, Heat-Strengthened, and Fully Tempered Flat Glass
C1376 Specification for Pyrolytic and Vacuum Deposition Coatings on Flat Glass
E1300 Practice for Determining Load Resistance of Glass in Buildings
ANSI Standard
Z97.1 Safety Performance Specifications and Methods of Test for Safety Glazing Materials Used in Buildings Available from American National Standards Institute, 25 W. 43rd St., 4th Floor, New York, NY 10036, and the Accredited Standards Committee Z97 website in electronic format at www.ansiz97.com.Keywords
edge compression; flat glass; heat-strengthened glass; heat-treated glass; surface compression; tempered glass ;
ICS Code
ICS Number Code 81.040.30 (Glass products)
DOI: 10.1520/C1048-97B
ASTM International is a member of CrossRef.
