Abstract

This specification covers the requirements for latex bonding agents suitable for use in brushes, brooms, or sprays. The bonding agents are intended for use in bonding fresh concrete to hardened concrete such as in interior surfaces, floors, roadways, bridge decks, ramps, runways, walks, and curbs. Each material should comply with the specified bond strength requirement for either of the two types of latex.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers latex bonding agents, suitable for brush, broom, or spray application, to bond fresh concrete to hardened concrete.

1.2 These bonding agents are intended for bonding new concrete to old concrete such as interior surfaces, floors, roadways, bridge decks, ramps, runways, walks, and curbs.

1.3 The values stated in either inch-pound units or SI units shall be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents, therefore, each system must be used independently of the other without combining values in any way.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C1042 Test Method for Bond Strength of Latex Systems Used With Concrete By Slant Shear

Keywords

adhesives; bonding agents; latex; Additives--cement/concrete; Bridge/structural materials--specifications; Brush/broom application; Concrete admixtures--specifications; Concrete bonding; Concrete construction materials/applications--specifications; Curbs; Flooring/floor covering systems--specifications; Hardened concrete--specifications; Installation--building materials/applications; Latex bonding agents; Pavement surfaces--specifications; Ramps/runways; Spray-on materials;

ICS Code

ICS Number Code 91.100.50 (Binders. Sealing materials)

DOI: 10.1520/C1059_C1059M-99R08

ASTM International is a member of CrossRef.

ASTM C1059 / C1059M