ASTM C120/C120M-09
Historical Standard: ASTM C120/C120M-09 Standard Test Methods of Flexure Testing of Slate (Breaking Load, Modulus of Rupture, Modulus of Elasticity)
SUPERSEDED (see Active link, below)
ASTM C120 / C120M
1. Scope
1.1 These test methods cover determination of the breaking load, modulus of rupture and modulus of elasticity of slate by means of flexure tests.
1.2 Units The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C119 Terminology Relating to Dimension Stone
Keywords
breaking load; dimension stone; flexure; modulus of elasticity; modulus of rupture; slate; test;
ICS Code
ICS Number Code 91.100.15 (Mineral materials and products)
DOI: 10.1520/C0120_C0120M-09
ASTM International is a member of CrossRef.
