ASTM C1339-02
Historical Standard: ASTM C1339-02 Standard Test Method for Flowability and Bearing Area of Chemical-Resistant Polymer Machinery Grouts
SUPERSEDED (see Active link, below)
ASTM C1339
1. Scope
1.1 This test method covers the measure of flowability of chemical-resistant polymer machinery grouts as evaluated in a 2-in. (5-cm) or 1-in. (2.5-cm) pour thickness. The test method provides for the assessment of upper surface plate contact area (bearing area). These grouts will typically be two- or three-component formulations that may be used for installations where grout thickness will range from 1 to 6 in. (2.5 to 15 cm) underneath the base or plates being grouted.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C904 Terminology Relating to Chemical-Resistant Nonmetallic Materials
Keywords
bearing area; chemical-resistant polymer machinery grout; flowability; surface contact;
ICS Code
ICS Number Code 83.020 (Manufacturing processes in the rubber and plastics industries)
DOI: 10.1520/C1339-02
ASTM International is a member of CrossRef.
