ASTM C1761/C1761M-13
Historical Standard: ASTM C1761/C1761M-13 Standard Specification for Lightweight Aggregate for Internal Curing of Concrete
SUPERSEDED (see Active link, below)
ASTM C1761 / C1761M
1. Scope
1.1 This specification covers lightweight aggregate intended to provide water for internal curing of concrete. It includes test methods for determining the absorption and desorption properties of lightweight aggregate.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance. Some values have only SI units because the inch-pound equivalents are not used in practice.
1.3 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C29/C29M Test Method for Bulk Density (Unit Weight) and Voids in Aggregate
C40 Test Method for Organic Impurities in Fine Aggregates for Concrete
C87 Test Method for Effect of Organic Impurities in Fine Aggregate on Strength of Mortar
C114 Test Methods for Chemical Analysis of Hydraulic Cement
C125 Terminology Relating to Concrete and Concrete Aggregates
C128 Test Method for Density, Relative Density (Specific Gravity), and Absorption of Fine Aggregate
C136 Test Method for Sieve Analysis of Fine and Coarse Aggregates
C142 Test Method for Clay Lumps and Friable Particles in Aggregates
C330/C330M Specification for Lightweight Aggregates for Structural Concrete
C641 Test Method for Iron Staining Materials in Lightweight Concrete Aggregates
C702 Practice for Reducing Samples of Aggregate to Testing Size
C1498 Test Method for Hygroscopic Sorption Isotherms of Building Materials
C1608 Test Method for Chemical Shrinkage of Hydraulic Cement Paste
C1698 Test Method for Autogenous Strain of Cement Paste and Mortar
D75 Practice for Sampling Aggregates
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
Keywords
absorption; desorption; internal curing; lightweight aggregate; relative density; wetted surface dry;
ICS Code
ICS Number Code 91.100.30 (Concrete and concrete products)
DOI: 10.1520/C1761_C1761M
ASTM International is a member of CrossRef.
