1. Scope

1.1 This test method covers procedures for measuring diagonal and edge warpages of the following categories of ceramic tile:

1.1.1 Square Tile 2 by 2 in. (51 by 51 mm) or larger, that are nominally flat, of uniform overall thickness, and have a smooth face of one of the types: unglazed, bright glazed, matte glazed, or finely crystalline glazed.

1.1.2 Oblong Tile, no facial dimension smaller than 2 in. (51 mm), that are flat, of uniform overall thickness, and have a smooth face of one of the types: unglazed, bright glazed, matte glazed, or finely crystalline glazed.

1.1.3 Square and Oblong Tile, no facial dimension smaller than 2 in. (51 mm), that are flat, but have an irregular face such as embossed, sloped, bumpy, wavy, coarsely crystalline, or wire-cut textured.

1.1.4 Non-Rectilinear Tile, larger than 4 in. (26 cm ), that are flat and of uniform body thickness with smooth or irregular face, such as hexagonal, diamond, Spanish type, etc.

1.1.5 Trim Tile meeting one of the descriptions in 1.1.1 through 1.1.4 except that only a part of the tile surface is flat. (Surface trim tile should be treated as flat tile whenever possible.)

1.1.6 Square or Oblong Tile with facial area less than 4 in. (26 cm ) and at least two straight sides equal to or greater than 1.0 in. (25 mm) long. (Modular 1 by 1 in.-tile are not in the scope of this test method.)

1.2 This test method is not applicable to tile having embossed surfaces that are not flat, or that have a combination of variable body thickness and an irregular face.

1.3 The values stated in the inch-pound units are to be regarded as the standard. The SI (metric) units given in parentheses are for information only.

1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C242 Terminology of Ceramic Whitewares and Related Products

Keywords

ceramic tile; warpage; Ceramic tile; Length; Warpage;

ICS Code

ICS Number Code 91.100.25 (Terracotta building products)

DOI: 10.1520/C0485-83R99

ASTM International is a member of CrossRef.