1. Scope

1.1 This specification applies to those elastomeric cellular materials of a firm grade that are manufactured in preformed shapes for use as gaskets and for use as sealing materials, in the form of compression seals or gaskets, or both, for glazing other building joint applications.

1.2 Test Method C1166, as referenced in this specification, should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use.

1.3 The following precautionary caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C717 Terminology of Building Seals and Sealants

C1083 Test Method for Water Absorption of Cellular Elastomeric Gaskets and Sealing Materials

C1166 Test Method for Flame Propagation of Dense and Cellular Elastomeric Gaskets and Accessories

D395 Test Methods for Rubber Property--Compression Set

D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension

D746 Test Method for Brittleness Temperature of Plastics and Elastomers by Impact

D865 Test Method for Rubber--Deterioration by Heating in Air (Test Tube Enclosure)

D925 Test Methods for Rubber Property--Staining of Surfaces (Contact, Migration, and Diffusion)

D1056 Specification for Flexible Cellular Materials--Sponge or Expanded Rubber

D1149 Test Methods for Rubber Deterioration--Cracking in an Ozone Controlled Environment

Keywords

cellular; compression; elastomer; elastomeric; gasket; glazing; preformed; seal; sealing; Cellular materials; Compression seals--specifications; Elastomeric seals/sealants--specifications; Gaskets--specifications; Glazing compounds/applications--specifications; Preformed sealant tapes--specifications; Sealants--specifications;

ICS Code

ICS Number Code 83.140.50 (Seals)

DOI: 10.1520/C0509-00

ASTM International is a member of CrossRef.