ASTM C803/C803M-03
Historical Standard: ASTM C803/C803M-03 Standard Test Method for Penetration Resistance of Hardened Concrete
SUPERSEDED (see Active link, below)
ASTM C803 / C803M
1. Scope
1.1 This test method covers the determination of the resistance of hardened concrete to penetration by either a steel probe or pin.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C125 Terminology Relating to Concrete and Concrete Aggregates
C670 Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials
ANSI Standard
A10.3 Safety Requirements for Powder Actuated Fastening Systems Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
concrete strength; concrete uniformity; in-place strength; in-place test; penetration resistance; Hardened concrete; Nondestructive evaluation (NDE)--concrete/masonry; Penetration--cement/concrete; Probe methods; Steel probe; Strength--cement/concrete mixtures/applications; Uniformity of concrete; Windsor probe method;
ICS Code
ICS Number Code 91.100.30 (Concrete and concrete products)
DOI: 10.1520/C0803_C0803M-03
ASTM International is a member of CrossRef.
