ASTM D1617-07
Historical Standard: ASTM D1617-07 Standard Test Method for Ester Value of Solvents and Thinners
SUPERSEDED (see Active link, below)
ASTM D1617
1. Scope
1.1 This test method covers the determination of the ester value of solvents and thinners used in lacquers and other coatings.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 For purposes of determining conformance of an observed or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off 'to the nearest unit' in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 8.6.
1.4 For hazard information and guidance, see the supplier's Material Safety Data Sheet.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1193 Specification for Reagent Water
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
Keywords
ester value; solvents; thinner;
ICS Code
ICS Number Code 87.060.30 (Solvents)
DOI: 10.1520/D1617-07
ASTM International is a member of CrossRef.
