ASTM D2307-07a
Historical Standard: ASTM D2307-07a Standard Test Method for Thermal Endurance of Film-Insulated Round Magnet Wire
SUPERSEDED (see Active link, below)
ASTM D2307
1. Scope
1.1 This test method covers determination of the thermal endurance of film-insulated round magnet wire in air at atmospheric pressure. It is not applicable to magnet wire with fibrous insulation, such as cotton or glass.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI units in parentheses are provided for information only.
1.3 This test method covers the evaluation of thermal endurance by observing changes in response to ac proof voltage tests. The evaluation of thermal endurance by observing changes in other properties of magnet wire insulation requires the use of different test methods.
1.4 It is possible that exposure of some types of film insulated wire to heat in gaseous or liquid environments in the absence of air will give thermal endurance values different from those obtained in air. Consider this possibility when interpreting the results obtained by heating in air with respect to applications where the wire will not be exposed to air in service.
1.5 It is possible that electric stress applied for extended periods at a level exceeding or even approaching the discharge inception voltage will change significantly the thermal endurance of film insulated wires. Under such electric stress conditions, it is possible that comparisons between materials will also differ from those developed using this method.
1.6 This test method is similar to IEC 60172. Differences exist regarding specimen preparation.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Other Standards
IEC 60172 Statistical Analysis of Thermal Life Test Data Available from International Electrotechnical Commission (IEC), 3 rue de Varemb, Case postale 131, CH-1211, Geneva 20, Switzerland, http://www.iec.ch. IEEE 101 Statistical Analysis of Thermal Life Test Data Available from Institute of Electrical and Electronics Engineers, Inc. (IEEE), 445 Hoes Ln., P.O. Box 1331, Piscataway, NJ 08854-1331, http://www.ieee.org.ASTM Standards
D1676 Test Methods for Film-Insulated Magnet Wire
D1711 Terminology Relating to Electrical Insulation
D3251 Test Method for Thermal Endurance Characteristics of Electrical Insulating Varnishes Applied Over Film-Insulated Magnet Wire
D5423 Specification for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation
Keywords
correlation coefficient; linearity; magnet wire; temperature index; thermal endurance;
ICS Code
ICS Number Code 29.060.10 (Wires)
DOI: 10.1520/D2307-07A
ASTM International is a member of CrossRef.
