ASTM D2511-93(2003)
Historical Standard: ASTM D2511-93(2003) Standard Test Method for Thermal Shock Sensitivity of Solid Film Lubricants
SUPERSEDED (see Active link, below)
ASTM D2511
1. Scope
1.1 This test method covers the measurement of the resistance of dry solid film lubricants to deterioration when subjected to temperature extremes.
1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A167 Specification for Stainless and Heat-Resisting Chromium-Nickel Steel Plate, Sheet, and Strip
D2510 Test Method for Adhesion of Solid Film Lubricants
D4175 Terminology Relating to Petroleum, Petroleum Products, and Lubricants
U.S. Federal Specification
P-D-680 Dry Cleaning Solvent Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098.Keywords
solid film lubricant; thermal shock; Lubricants (solid); Solid film lubricant; Thermal shock materials/testing;
ICS Code
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
DOI: 10.1520/D2511-93R03
ASTM International is a member of CrossRef.
