ASTM D2524-95(2003)
Historical Standard: ASTM D2524-95(2003) Standard Test Method for Breaking Tenacity of Wool Fibers, Flat Bundle Method- 1/8-in. (3.2-mm) Gage Length
SUPERSEDED (see Active link, below)
ASTM D2524
1. Scope
1.1 This test method covers the determination of the breaking tenacity of wool fibers as a flat bundle with a 1/8-in. (3.2-mm) clamp separation.
1.2 This test method is especially adapted to the fiber bundle clamps and strength testing instruments specified, but may be used on other tensile testing machines when equipped with appropriate adapters to accommodate the prescribed clamps.
1.3 This test method is applicable to wool in any form which can be hand-combed into small bundles of parallelized fibers.
Note 1Other test methods for measuring breaking tenacity of fiber bundles include Test Methods D 1294, D 1445, and D 540.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units in parentheses are provided for information only.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D123 Terminology Relating to Textiles
D540 Methods of Testing Man-Made Staple Fibers; Replaced by D 3660
D1294 Test Method for Tensile Strength and Breaking Tenacity of Wool Fiber Bundles 1-in. (25.4-mm) Gage Length
D1445 Test Method for Breaking Strength and Elongation of Cotton Fibers (Flat Bundle Method)
D1776 Practice for Conditioning and Testing Textiles
D2525 Practice for Sampling Wool for Moisture
Keywords
breaking tenacity; fibers; wool ;
ICS Code
ICS Number Code 59.060.10 (Natural fibres)
DOI: 10.1520/D2524-95R03
ASTM International is a member of CrossRef.
