ASTM D3233-93(1998)
Historical Standard: ASTM D3233-93(1998) Standard Test Methods for Measurement of Extreme Pressure Properties of Fluid Lubricants (Falex Pin and Vee Block Methods)
SUPERSEDED (see Active link, below)
ASTM D3233
1. Scope
1.1 These test methods cover two procedures for making a preliminary evaluation of the load-carrying properties of fluid lubricants by means of the Falex Pin and Vee Block Test Machine.
Note 1-Additional information can be found in Appendix X1 regarding coefficient of friction, load gage conversions, and load gage cablibration curve.1.2 The values stated in SI units are to be regarded as standard. Because the equipment used in these test methods is available only in inch-pound units, the SI units are omitted when referring to the equipment and the test specimens.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B16/B16M Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines
D2670 Test Method for Measuring Wear Properties of Fluid Lubricants (Falex Pin and Vee Block Method)
D2783 Test Method for Measurement of Extreme-Pressure Properties of Lubricating Fluids (Four-Ball Method)
Keywords
extreme pressure; Falex Pin and Vee Block; load-carrying; lubricant; wear; Falex method; Load-carrying capacity--lubricants; Lubricants (fluid); Pin and vee block; EP (extreme-pressure) lubricants; Pressure testing--petroleum products; Vee Block method; Wear testing--petroleum products ;
ICS Code
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
DOI: 10.1520/D3233-93R98
ASTM International is a member of CrossRef.
