ASTM D3763-02
Historical Standard: ASTM D3763-02 Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors
SUPERSEDED (see Active link, below)
ASTM D3763
1. Scope
1.1 This test method covers the determination of puncture properties of plastics, including films, over a range of test velocities.
1.2 Test data obtained by this test method is relevant and appropriate for use in engineering design.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1This specification does not closely conform to ISO 6603.2. The only similarity between the two tests is that they are both instrumented impact tests. The differences in striker, fixture, and specimen geometries and in test velocity can produce significantly different test results.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D618 Practice for Conditioning Plastics for Testing
D883 Terminology Relating to Plastics
D1600 Terminology for Abbreviated Terms Relating to Plastics
D4000 Classification System for Specifying Plastic Materials
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ISO Standard
ISO 6603.2 Plastics--Determination of Multiaxial Impact Behavior of Rigid Plastics Part 2: Instrumented Puncture TestKeywords
falling weight; impact testing; plastics; puncture properties; Deformation--plastics; Falling weight test; High speed puncture properties; Impact resistance--plastics; Impact testing--plastics; Loading tests--plastics; Minimum instrumentation requirements; Multiaxial impact testing; Puncture; Rigid plastics; Velocity ;
ICS Code
ICS Number Code 83.080.01 (Plastics in general)
DOI: 10.1520/D3763-02
ASTM International is a member of CrossRef.
