ASTM D3795-00a
Historical Standard: ASTM D3795-00a Standard Test Method for Thermal Flow, Cure, and Behavior Properties of Pourable Thermosetting Materials by Torque Rheometer
SUPERSEDED (see Active link, below)
ASTM D3795
1. Scope
1.1 This test method covers the apparatus, and a specific test method, including the evaluation of results required for the determination of the thermal flow and cure behavior properties of pourable thermosetting materials.
1.2 This test method can be used:
1.2.1 As a control for the development and production of pourable thermosetting materials and to measure the different properties (for example, melting behavior, cure behavior, etc.) as well as the influence of various additives and fillers in any given formulations, and
1.2.2 Verify the uniformity of different production batches of the same formulation.
1.3 The values are stated in SI units.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautions are given in Section 7.
Note 1--There is no similar or equivalent ISO standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D792 Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
D883 Terminology Relating to Plastics
D1898 Practice for Sampling of Plastics
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Keywords
flow/cure properties; pourable; thermosets; torque rheometer;
ICS Code
ICS Number Code 83.080.01 (Plast in general)
DOI: 10.1520/D3795-00A
ASTM International is a member of CrossRef.
