ASTM D3963/D3963M-00a
Historical Standard: ASTM D3963/D3963M-00a Standard Specification for Fabrication and Jobsite Handling of Epoxy-Coated Steel Reinforcing Bars
SUPERSEDED (see Active link, below)
ASTM D3963 / D3963M
1. Scope
1.1 This specification covers the fabrication and jobsite requirements for deformed and plain steel reinforcing bars with protective epoxy coating applied in accordance with Specification A775.
1.2 This specification is applicable for orders in either inch-pound units (as Specification D3963) or SI units (as Specification D3963M).
1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A775/A775M Specification for Epoxy-Coated Steel Reinforcing Bars
B117 Practice for Operating Salt Spray (Fog) Apparatus
D374 Test Methods for Thickness of Solid Electrical Insulation
D2967 Test Method for Corner Coverage of Powder Coatings
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
G20 Test Method for Chemical Resistance of Pipeline Coatings
Federal Highway Administration Report
FHWA-RD-74-18 Nonmetallic Coatings for Concrete Reinforcing Bars Available from National Technical Information Service (NTIS), 5285 Port Royal Rd., Springfield, VA 22161, http://www.ntis.gov.Keywords
coating requirements; concrete reinforcement; corrosion resistance; epoxy coating; fabrication repair; field repair; steel bars; Chemical resistance; Chloride permeability; Concrete reinforcement specifications; Corrosion-resistant steel specifications; Edge coverage; Epoxy-coated steel bars specifications; Fabricated materials specifications; Field repair; Jobsite handling; Pavement surfaces specifications; Salt spray resistance; Steel bars (concrete reinforcement- specifications)
ICS Code
ICS Number Code 77.140.60 (Steel bars and rods)
DOI: 10.1520/D3963_D3963M-00A
ASTM International is a member of CrossRef.
