ASTM D4682-08
Historical Standard: ASTM D4682-08 Standard Specification for Miscibility with Gasoline and Fluidity of Two-Stroke-Cycle Gasoline Engine Lubricants
SUPERSEDED (see Active link, below)
ASTM D4682
1. Scope
1.1 This specification covers four categories of lubricants intended for use in two-stroke-cycle spark-ignition gasoline engines based on their miscibility with gasoline and their low-temperature fluidity.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 The following safety hazards caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D97 Test Method for Pour Point of Petroleum Products
D439 Specification for Automotive Gasoline
D445 Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)
D874 Test Method for Sulfated Ash from Lubricating Oils and Additives
D2983 Test Method for Low-Temperature Viscosity of Lubricants Measured by Brookfield Viscometer
Keywords
gasoline; low-temperature fluidity; miscibility;
ICS Code
ICS Number Code 75.160.20 (Liquid fuels)
DOI: 10.1520/D4682-08
ASTM International is a member of CrossRef.
