ASTM D4858-02
Historical Standard: ASTM D4858-02 Standard Test Method for Determination of the Tendency of Lubricants to Promote Preignition in Two-Stroke-Cycle Gasoline Engines
SUPERSEDED (see Active link, below)
ASTM D4858
1. Scope
1.1 This test method evaluates the performance of lubricants intended for use in two-stroke-cycle spark-ignition gasoline engines which are prone to preignition.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The values stated in SI units are the standard. The values given in parentheses are provided for information only.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B152/B152M Specification for Copper Sheet, Strip, Plate, and Rolled Bar
D439 Specification for Automotive Gasoline
D445 Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)
D664 Test Method for Acid Number of Petroleum Products by Potentiometric Titration
D874 Test Method for Sulfated Ash from Lubricating Oils and Additives
D910 Specification for Aviation Gasolines
D2270 Practice for Calculating Viscosity Index from Kinematic Viscosity at 40 and 100C
D2699 Test Method for Research Octane Number of Spark-Ignition Engine Fuel
D2700 Test Method for Motor Octane Number of Spark-Ignition Engine Fuel
D2885 Test Method for Determination of Octane Number of Spark-Ignition Engine Fuels by On-Line Direct Comparison Technique
D2896 Test Method for Base Number of Petroleum Products by Potentiometric Perchloric Acid Titration
D4857 Test Method for Determination of the Ability of Lubricants to Minimize Ring Sticking and Piston Deposits in Two-Stroke-Cycle Gasoline Engines Other Than Outboards
D4863 Test Method for Determination of Lubricity of Two-Stroke-Cycle Gasoline Engine Lubricants
E230 Specification and Temperature-Electromotive Force (EMF) Tables for Standardized Thermocouples
ANSI Standard
ANSIMC96.1 American National Standard for Temperature Measurement Thermocouples Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
air-cooled; lubricant; preignition; two-cycle gasoline engine;
ICS Code
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
DOI: 10.1520/D4858-02
ASTM International is a member of CrossRef.
