|
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of ASTM-D4942 2011ASTM D4942 - 11Standard Test Methods for Water Pickup of Lithographic Printing Inks and Vehicles in a Laboratory MixerActive Standard ASTM D4942 | Developed by Subcommittee: D01.56 Book of Standards Volume: 06.02 ASTM D4942Significance and Use
The lithographic printing process requires that some dampening solution be emulsified into the ink. These test methods provide a rapid means for determining water pickup under laboratory conditions. Test results may be useful for specification acceptance between the supplier and the customer. In order that results be comparable, the tests must be run at the same temperature and with the same type and quantity of liquid added prior to mixing. The emulsions obtained in these test methods are of larger particle size than those typically produced in printing nips. Because of these and other variables in the printing process, water pickup results do not by themselves predict lithographic printing performance. 1. Scope
1.1 These test methods cover two procedures for determining the amount of water picked up by lithographic printing inks in a laboratory mixer. 1.2 Test Method A covers single-point water pickup; Test Method B covers the rate of water pickup. Both test methods are applicable to any printing ink and vehicle intended for the lithographic printing process. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Keywords emulsification; fountain solution; inks; lithographic printing inks; mixers ; printing inks; vehicles; water content; water pickup; Gravimetric determination; Ink; Laboratory mixer; Lithographic materials/applications; Printing inks/vehicles; Volumetric measurement; Water analysis; Water pickup ; ICS Code ICS Number Code 87.080 (Inks. Printing inks) DOI: 10.1520/D4942-11 ASTM D4942 |
US LOCAL CODES
US Territory Code Adoptions / Amendments
US State Code Adoptions / Amendments
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|