ASTM D5013-89(1998)
Historical Standard: ASTM D5013-89(1998) Standard Practices for Sampling Wastes from Pipes and Other Point Discharges
SUPERSEDED (see Active link, below)
ASTM D5013
1. Scope
1.1 Those practices provide guidance for obtaining samples of waste at discharge points from pipes, sluiceways, conduits, and conveyor belts. The following are included:
Sections Practice A---Liquid or Slurry Discharges 7 through 9 Practice B---Solid or Semisolid Discharges 10 through 121.2 These practices are intended for situations in which there are no other applicable ASTM sampling methods (see Practices D140 and D75) for the specific industry.
1.3 These practices do not address flow and time-proportional samplers and other automatic sampling devices.
1.4 Samples are taken from a flowing waste stream or moving waste mass and, therefore, are descriptive only within a certain period. The length of the period for which a sample is descriptive will depend on the sampling frequency and compositing scheme.
1.5 It is recommended that these practices be used in conjunction with ASTM Guide D4687.
1.6 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 5 for more information.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D75 Practice for Sampling Aggregates
D140 Practice for Sampling Bituminous Materials
D4687 Guide for General Planning of Waste Sampling
E882 Guide for Accountability and Quality Control in the Chemical Analysis Laboratory
Other Document
EPA-SW-846 Test Methods for Evaluating Solid Waste, Physical/Chemical Methods Available from Superintendent of Documents, U.S. Government Printing Office, Washington, DC 20402.Keywords
samples; waste; devices; Conduits; Conveyor belts; Discharge measurement; Drainage materials/systems; Land drainage piping systems; Liquid waste; Sampling waste materials/applications; Semi-solid materials; Sewer pipe; Sluiceways; Slurries; Solid phase materials--waste; Wastewater testing/treatment
ICS Code
ICS Number Code 13.030.01 (Wastes in general)
DOI: 10.1520/D5013-89R98
ASTM International is a member of CrossRef.
