ASTM D516-90(1995)e1
Historical Standard: ASTM D516-90(1995)e1 Standard Test Method for Sulfate Ion in Water
SUPERSEDED (see Active link, below)
ASTM D516
1. Scope
1.1 This turbidimetric test method covers the determination of sulfate in water in the range from 1 to 40 mg/L of sulfate ion (SO 4 ).
1.2 This test method was used successfully with drinking, ground, and surface waters. It is the user's responsibility to ensure the validity of this test method for waters of untested matrices.
1.3 Former gravimetric and volumetric test methods have been discontinued. Refer to Appendix X1 for historical information.
1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1066 Practice for Sampling Steam
D1129 Terminology Relating to Water
D1193 Specification for Reagent Water
D2777 Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
D3370 Practices for Sampling Water from Closed Conduits
D5847 Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis
E60 Practice for Analysis of Metals, Ores, and Related Materials by Spectrophotometry
E275 Practice for Describing and Measuring Performance of Ultraviolet and Visible Spectrophotometers
Keywords
drinking water; ground water; sulfate; surface water; turbidimetric: Inorganic compounds--water; Sulfate content--water;
ICS Code
ICS Number Code 13.060.50 (Examination of water for chemical substances)
DOI: 10.1520/D0516-90R95E01
ASTM International is a member of CrossRef.
