ASTM D5702-07
Historical Standard: ASTM D5702-07 Standard Practice for Field Sampling of Coating Films for Analysis for Heavy Metals
SUPERSEDED (see Active link, below)
ASTM D5702
1. Scope
1.1 This practice covers a method to control the removal of samples of coating films from substrates for subsequent laboratory analysis for heavy metal content on a mass basis. This technique can be used in the field, the fabricating shop, or laboratory.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard information, see Section 5, Note 1 and Note 3.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D4138 Practices for Measurement of Dry Film Thickness of Protective Coating Systems by Destructive, Cross-Sectioning Means
D6132 Test Method for Nondestructive Measurement of Dry Film Thickness of Applied Organic Coatings Using an Ultrasonic Gage
D7091 Practice for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to Ferrous Metals and Nonmagnetic, Nonconductive Coatings Applied to Non-Ferrous Metals
Keywords
coating film sampling; coating film identification; hazardous elements; heavy metals; paint film identification; paint film sampling; sampling;
ICS Code
ICS Number Code 13.040.01 (Air quality in general)
DOI: 10.1520/D5702-07
ASTM International is a member of CrossRef.
