ASTM D5801-95(2006)e1
Historical Standard: ASTM D5801-95(2006)e1 Standard Test Method for Toughness and Tenacity of Bituminous Materials
SUPERSEDED (see Active link, below)
ASTM D5801
1. Scope
1.1 This test method describes the procedure for measuring the toughness and tenacity of bituminous materials. Typically, the test method has been used to characterize elastomer modified asphalts, although values for toughness and tenacity may be obtained for any type of polymer-modified or non-modified asphalt.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.2 The values given in SI units are to be regarded as the standard. The values given in inch-pound units in parentheses are for informational purposes only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D5 Test Method for Penetration of Bituminous Materials
E1 Specification for ASTM Liquid-in-Glass Thermometers
Keywords
asphalt cement; polymer modified asphalt; tenacity; tensile testing; toughness ;
ICS Code
ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products); 91.100.50 (Binders. Sealing materials)
DOI: 10.1520/D5801-95R06E01
ASTM International is a member of CrossRef.
