ASTM D5874-95
Historical Standard: ASTM D5874-95 Standard Test Method for Determination of the Impact Value (IV) of a Soil
SUPERSEDED (see Active link, below)
ASTM D5874
1. Scope
1.1 This test method covers the determination of the Impact Value (IV) of a soil either in the field or a test mold.
1.2 The standard test method, using a 4.5 kg (10 lbm) hammer, is suitable for, but not limited to, evaluating the strength of an unsaturated compacted fill, in particular pavement materials, soils, and soil-aggregates having maximum particle sizes less than 37.5 mm (1.5 in.).
1.3 By using a lighter 0.5 kg (1.1 lbm) hammer, this test method is applicable for evaluating lower strength soils such as fine grained cohesionless, highly organic, saturated, or highly plastic soils having a maximum particle size less than 9.5 mm (0.375 in.).
1.4 By performing laboratory test correlations for a particular soil using the 4.5 kg (10 lbm) hammer, IV may be correlated with an unsoaked California Bearing Ratio (CBR) or may be used to infer percentage compaction.
1.5 The values stated SI are to be regarded as the standard. The values stated in parentheses are given for information only.
1.6 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1-The equipment and procedures contained in this test method are similar to those developed by B. Clegg in the 1970s at the University of Western Australia, Nedlands, Australia. Impact Value is also commonly known as Clegg Impact Value (CIV).
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D653 Terminology Relating to Soil, Rock, and Contained Fluids
D698 Test Methods for Laboratory Compaction Characteristics of Soil Using Standard Effort (12 400 ft-lbf/ft3 (600 kN-m/m3))
D1556 Test Method for Density and Unit Weight of Soil in Place by Sand-Cone Method
D1557 Test Methods for Laboratory Compaction Characteristics of Soil Using Modified Effort (56,000 ft-lbf/ft3 (2,700 kN-m/m3))
D1883 Test Method for CBR (California Bearing Ratio) of Laboratory-Compacted Soils
D2167 Test Method for Density and Unit Weight of Soil in Place by the Rubber Balloon Method
D2216 Test Methods for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass
D2922 Test Methods for Density of Soil and Soil-Aggregate in Place by Nuclear Methods (Shallow Depth)
D2937 Test Method for Density of Soil in Place by the Drive-Cylinder Method
D3740 Practice for Minimum Requirements for Agencies Engaged in Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction
D4643 Test Method for Determination of Water (Moisture) Content of Soil by Microwave Oven Heating
D4959 Test Method for Determination of Water (Moisture) Content of Soil By Direct Heating
D6026 Practice for Using Significant Digits in Geotechnical Data
Keywords
acceptance test; clegg impact value; compaction control; impact soil test; impact test; impact test hammer; impact value; light impact value; soil test; stabilization testing; strength test; trench testing; turf testing;
ICS Code
ICS Number Code 13.080.20 (Physical properties of soil)
DOI: 10.1520/D5874-95
ASTM International is a member of CrossRef.
