ASTM D6667
Scope
1.1 This test method covers the determination of total volatile sulfur in gaseous hydrocarbons and liquefied petroleum (LP) gases. It is applicable to
analysis of natural, processed, and final product materials. Precision has been determined for sulfur in gaseous hydrocarbons in the range of 1 mg/kg to 100 mg/kg and for sulfur in LP gases in
the range of 1 mg/kg to 196 mg/kg (Note 1).
Note 1: An estimate of pooled limit of quantification (PLOQ), information regarding sample
stability and other general information derived from the interlaboratory studies on precision can be referenced in the ASTM research reports.,
1.2 This test method may not detect sulfur compounds that do not vaporize under the conditions of the test.
1.3 This test method is applicable for total volatile sulfur determination in LP gases containing less than 0.35 % (mass/mass) halogen(s).
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this
standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See 3.1 and Sections 6 and 7 for specific warning statements.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on
Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
analysis; butane; fluorescence; gases; hydrocarbon; isobutane; LP; LPG; liquefied; petroleum; propane; sulfur; ultraviolet;
ICS Code
ICS Number Code 19.100 (Non-destructive testing)
DOI: 10.1520/D6667-21
