ASTM D732-99
Historical Standard: ASTM D732-99 Standard Test Method for Shear Strength of Plastics by Punch Tool
SUPERSEDED (see Active link, below)
ASTM D732
1. Scope
1.1 This test method covers the punch-type of shear test and is intended for use in determining the shear strength of test specimens of organic plastics in the form of sheets and molded disks in thicknesses from 0.127 to 12.7 mm (0.050 to 0.500 in.).
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1There is no known ISO equivalent to this standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D618 Practice for Conditioning Plastics for Testing
D4000 Classification System for Specifying Plastic Materials
E4 Practices for Force Verification of Testing Machines
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Keywords
punch tool; shear strength; Organic plastic sheet/molded disks; Punch tool; Shear testing--plastics;
ICS Code
ICS Number Code 83.080.01 (Plastics in general)
DOI: 10.1520/D0732-99
ASTM International is a member of CrossRef.
