ASTM D7331-07
Historical Standard: ASTM D7331-07 Standard Practice for Sewn Products Marker Data Interchange
SUPERSEDED (see Active link, below)
ASTM D7331
1. Scope
1.1 This practice describes a format for transferring marker data from a CAD marker software system to another or to a CAM software system.
1.2 This practice does not support curve interpolation or definitions. All curves are represented by discrete vectors and are dependent on the resolution of the CAD software
1.3 This practice is concerned in limiting differences when processing the same data on different CAD systems.
1.4 This practice is not intended to represent the dimension relationships between pattern pieces or between pattern sizes, or the correspondence between 2D or 3D sewn product pattern piece geometries.
1.5 This practice does not specify the file format for the marker data exchange.
1.6 A consistent XML implementation of this practice is recommended.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D6963 Terminology Relating to Sewn Products Automation
Keywords
CAD system; cutting; geometry; nest; piece; sewn product; CAD/CAM systems; Textile publications; Sewn products pattern data interchange;
ICS Code
ICS Number Code 35.240.10 (Computer-aided design (CAD))
DOI: 10.1520/D7331-07
ASTM International is a member of CrossRef.
