ASTM D7704-11
Historical Standard: ASTM D7704-11 Standard Test Method for Total Aldehydes in Styrene Monomer by Potentiometric Titration
SUPERSEDED (see Active link, below)
ASTM D7704
1. Scope
1.1 This test method covers the wet chemical determination of aldehydes in styrene monomer. Aldehydes are calculated and reported as benzaldehyde. The range of concentration for this test method is 0.001 mass % to 0.030 mass %.
1.2 In determining conformance of the test results using this method to applicable specifications, results shall be rounded off in accordance with the rounding-off method of Practice E29 .
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1193 Specification for Reagent Water
D3437 Practice for Sampling and Handling Liquid Cyclic Products
D6809 Guide for Quality Control and Quality Assurance Procedures for Aromatic Hydrocarbons and Related Materials
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
Other Documents
OSHARegulations,29CF paragraphs 1910.1000 and 1910.1200 Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://dodssp.daps.dla.mil.Keywords
aldehyde content; aldehydes in styrene; benzaldehyde; styrene; Aldehydes; Aromatic hydrocarbons (AHs); Potentiometric titration; Styrene--monomer
ICS Code
ICS Number Code 71.080.15 (Aromatic hydrocarbons)
DOI: 10.1520/D7704-11
ASTM International is a member of CrossRef.
