ASTM E11-09
Historical Standard: ASTM E11-09 Standard Specification for Wire Cloth and Sieves for Testing Purposes
SUPERSEDED (see Active link, below)
Translated Standard: Russian
more info
ASTM E11
1. Scope
1.1 This document specifies the technical requirements for; the woven wire test sieve cloth (sieve cloth) used in test sieves, the construction of test sieves, standard and non-standard test sieve frame sizes, and test procedures used to inspect sieve cloth and the test sieves. This Specification applies to test sieves manufactured with sieve cloth having a nominal aperture size ranging from 125 millimeters (mm) down to 20 micrometers ( ? m).
1.2 Additional reference information can be found in Specifications E 161 , E 323 , E 2016 , and in Test Methods C 430 and E 2427 .
1.3 The values stated in SI units shall be considered standard for the dimensions of the sieve cloth openings and the wire diameters used in the sieve cloth. The values stated in inch-pound units shall be considered standard with regard to the sieve frames, pans, and covers.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C430 Test Method for Fineness of Hydraulic Cement by the 45-m (No. 325) Sieve
E161 Specification for Precision Electroformed Sieves
E323 Specification for Perforated-Plate Sieves for Testing Purposes
E1638 Terminology Relating to Sieves, Sieving Methods, and Screening Media
E2016 Specification for Industrial Woven Wire Cloth
E2427 Test Method for Acceptance by Performance Testing for Sieves
Federal Standard
Fed.Std.No.123 Marking for Shipment (Civil Agencies) Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.Military Standard
MIL-STD-129 Marking for Shipment and StorageISO Standard
ISO3310-1 Test Sieves--Technical Requirements and Testing - Part 1: Test Sieves of Metal Wire Cloth Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
aperture; calibration sieve; compliance sieve; inspection sieve; opening; particle size; sieve; sieve analysis; sieve cloth; sieve designation; test sieve; woven wire test sieve cloth; Laboratory apparatus--specifications; Particle analysis; Particle size characterization; Sieve analysis; Sieves (wire cloth)--specifications; Test grade wire cloth/sieve; Testing methods--laboratory instrumentation;
ICS Code
ICS Number Code 19.120 (Particle size analysis. Sieving)
DOI: 10.1520/E0011-09
ASTM International is a member of CrossRef.