Abstract

This specification covers two types of lightweight electrical equipment shelters designed for transport on both the M1037 and M1097 high mobility multipurpose wheeled vehicle (HMMWV) by rail, air, marine, and highway when mounted or dismounted from their vehicles. The shelters will be of the following types: Type I shelters without tunnel(17-2-0035-1); and Type III modified general-purpose shelters with tunnel (17-2-0035-3). Shelters shall undergo rigid verification procedures to inspect their conformance to requirements pertaining to physical performance, environmental performance, transportability performance, identification, toxicity, and flame resistance.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers two types of lightweight electrical equipment shelters designed for transport on the M1152A1, M1152A1 with B2 Armor Kit, M1037, and M1097 High Mobility Multipurpose Wheeled Vehicle (HMMWV). These shelters are transported by rail, air, marine and highway when mounted or dismounted from their vehicles.

1.2 Classification The shelters will be of the following types, as specified (see 6.2).

1.2.1 Type I Shelter, Electrical Equipment, Lightweight (w/o Tunnel, 17-2-0035-1).

1.2.2 Type III Shelter, Electrical Equipment, Lightweight, Modified, General Purpose (w/ Tunnel, 17-2-0035-3).

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following safety hazards caveat pertains only to the test required portion, Section 4, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Federal Standard

Military Standards

Commercial Standard

ASTM Standards

E1851 Test Method for Electromagnetic Shielding Effectiveness of Durable Rigid Wall Relocatable Structures

E1925 Specification for Engineering and Design Criteria for Rigid Wall Relocatable Structures

ACGIH Documents

Drawings

Military Handbook

Keywords

command post; electronics; EMI shield; HMMWV; multipurpose; SICPS; Electrical equipment--specifications; Lightweight apparatus--specifications; Shelters--specifications;

ICS Code

ICS Number Code 29.260.99 (Other electrical equipment for working in special conditions)

DOI: 10.1520/E2377-10

ASTM International is a member of CrossRef.

ASTM E2377