ASTM E255-91(1997)
Historical Standard: ASTM E255-91(1997) Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
SUPERSEDED (see Active link, below)
ASTM E255
1. Scope
1.1 This practice describes the sampling of copper (except electrolytic cathode) and copper alloys in either cast or wrought form for the determination of composition.
1.2 Cast products may be in the form of cake, billet, wire bar, ingot, ingot bar, or casting.
1.3 Wrought products may be in the form of flat, pipe, tube, rod, bar, shape, or forging.
1.4 This practice is not intended to supersede or replace existing specification requirements for the sampling of a particular material.
1.5 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are given for information only.
1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific precautionary statement appears in Appendix X4.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E135 Terminology Relating to Analytical Chemistry for Metals, Ores, and Related Materials
Keywords
copper; copper alloys; sampling
ICS Code
ICS Number Code 77.040.30 (Chemical analysis of metals); 77.120.30 (Copper and copper alloys)
DOI: 10.1520/E0255-91R97
ASTM International is a member of CrossRef.
