ASTM E837-01e1
Historical Standard: ASTM E837-01e1 Standard Test Method for Determining Residual Stresses by the Hole-Drilling Strain-Gage Method
SUPERSEDED (see Active link, below)
ASTM E837
1. Scope
1.1 This test method covers the procedure for determining residual stresses near the surface of isotropic linearly-elastic materials. Although the concept is quite general, the test method described here is applicable in those cases where the stresses do not vary significantly with depth and do not exceed one half of the yield strength. The test method is often described as 'semi-destructive' because the damage that it causes is very localized and in many cases does not significantly affect the usefulness of the specimen. In contrast, most other mechanical methods for measuring residual stress substantially destroy the specimen. Since the test method described here does cause some damage, it should be applied only in those cases either where the specimen is expendable or where the introduction of a small shallow hole will not significantly affect the usefulness of the specimen.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E251 Test Methods for Performance Characteristics of Metallic Bonded Resistance Strain Gauges
Keywords
hole-drilling; integral method; residual stress measurement; strain gages; stress analysis ;
ICS Code
ICS Number Code 77.040.10 (Mechanical testing of metals)
DOI: 10.1520/E0837-01E01
ASTM International is a member of CrossRef.
