Abstract

This specification covers single- and double compression and self-closing faucets for shipboard plumbing installations. Faucets may be classified into nine types: Type I is the standard (bibb) with three classes namely Class A (compression, plain end), Class B (compression, hose end), and Class C (self-closing); Type II is a lavatory, self-closing, low spout faucet with two classes which are Class A (fast-closing) and Class B (slow-closing, depression type); Type III is a folding lavatory,self-closing faucet; Type IV is an elbow operated faucet, Type V is a faucet with lavatory, combination water supply and drain fixture; Type VI is a faucet with combination supply fixture swing spout for use on galley sinks; Type VII is a faucet with single supply fixture swing spout for use with steam kettles and urns and this type has two classes namely Class A which has spout for overhead supply and Class B which has spout for riser supply; Type VIII is a faucet with supply fixture for pressed metal and shock mounted china lavatories; and Type IX which is a faucet with lavatory and combination of water supply and drain fixtures. Faucet bodies shall be made of bronze and handles shall be of commercial grade cast or forged brass or bronze. Bonnets, handwheels, and nuts shall be of commercial quality brass or bronze; machine screws shall be made of commercial brass. Seat washers shall be of a rubber or fiber material and suitable for a certain water temperature range without deterioration of material. Springs for self-closing faucets shall be of corrosionresisting steel, phosphor bronze, or nickel copper. All samples shall be subjected to a hydrostatic test.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers single- and double-compression and self-closing faucets for shipboard plumbing installations.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 The following precautionary caveat pertains only to the test methods portion, Section 10, of this standard. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

B62 Specification for Composition Bronze or Ounce Metal Castings

B584 Specification for Copper Alloy Sand Castings for General Applications

American National Standards Institute Standard

Federal Specifications

Military Specification

Military Standards

Naval Sea Systems Command (NAVSEA)

Keywords

compression faucets; faucets; marine; plumbing; self-closing faucets; ship; shipboard ; Faucets; Marine systems/subsystems/equipment--specifications; Shipbuilding piping materials--specifications; Shipbuilding steel pipe materials--specifications

ICS Code

ICS Number Code 47.020.80 (Accommodation spaces)

DOI: 10.1520/F1245-89R12

ASTM International is a member of CrossRef.

ASTM F1245