ASTM F1309-98(2007)
Historical Standard: ASTM F1309-98(2007) Standard Practice for Installation Procedures for Fitting Chocks to Marine Machinery Foundations
SUPERSEDED (see Active link, below)
ASTM F1309
1. Scope
1.1 This practice covers the acceptable methods of fitting chocks to marine machinery foundations.
1.2 The values stated in SI units shall be regarded as standard. The values in parentheses are for information only.
1.3 This standard does not purport to address the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
D638 Test Method for Tensile Properties of Plastics
D648 Test Method for Deflection Temperature of Plastics Under Flexural Load in the Edgewise Position
D695 Test Method for Compressive Properties of Rigid Plastics
Other Documents
AmericanWeldingSocie Structural Welding Code Available from American Welding Society (AWS), 550 NW LeJeune Rd., Miami, FL 33126, http://www.aws.org.Keywords
chocks; fitting chocks; foundations; installation; machinery foundations, marine; procedures; ship;
ICS Code
ICS Number Code 47.020.20 (Marine engines and propulsion systems)
DOI: 10.1520/F1309-98R07
ASTM International is a member of CrossRef.
