ASTM F1460-93(1999)
Historical Standard: ASTM F1460-93(1999) Standard Practice for Calibrating Oil Spill Dispersant Application Equipment Boom and Nozzle Systems
SUPERSEDED (see Active link, below)
ASTM F1460
1. Scope
1.1 This practice covers uniform procedures for determining and reporting the dosage rate of oil spill dispersant application equipment.
1.2 This practice is applicable to spray systems employing booms and nozzles and is not fully applicable to other systems such as fire monitors, sonic distributors, or fan-spray guns.
1.3 This practice is applicable to systems for use on ships or boats and helicopters or airplanes.
1.4 This practice is one of four related to dispersant application systems. One is on design, one on calibration, one on deposition, and one on the use of the systems. Familiarity with all four standards is recommended. The other three standards are listed in Section 2.
1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
F1413 Guide for Oil Spill Dispersant Application Equipment: Boom and Nozzle Systems
Keywords
boom and nozzles; dispersant application; dispersant spray equipment; dispersants; oil spill chemicals; oil spill dispersants; oil spill treating agents ;
ICS Code
ICS Number Code 21.260 (Lubrication systems)
DOI: 10.1520/F1460-93R99
ASTM International is a member of CrossRef.
