Significance and Use

Threshold of Capture and Containment This test method describes flow visualization techniques that are used to determine the threshold of capture and containment (C & C) for idle and specified heavy cooking conditions. The threshold of C & C can be used to estimate minimum flow rates for hood/appliance systems.

Parametric Studies This test method also can be used to conduct parametric studies of alternative configurations of hoods, appliances, and replacement air systems. In general, these studies are conducted by holding constant all configuration and operational variables except the variable of interest. This test method, therefore, can be used to evaluate the following:

The overall system performance with various appliances, while holding the hood and replacement air system characteristics constant.

Entire hoods or characteristics of a single hood, such as end panels, can be varied with appliances and replacement air constant.

Replacement air characteristics, such as make-up air location, direction, and volume, can be varied with constant appliance and hood variables.

1. Scope

1.1 Characterization of capture and containment performance of hood, appliance(s), and replacement air system during cooking and non-cooking conditions (idle):

1.2 Parametric evaluation of operational or design variations in appliances, hoods, or replacement air configurations.

1.3 The test method to determine heat gain to space from commercial kitchen ventilation/appliance systems has been re-designated as Test Method F2474 .

1.4 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

F1275 Test Method for Performance of Griddles

F1361 Test Method for Performance of Open Deep Fat Fryers

F1484 Test Methods for Performance of Steam Cookers

F1496 Test Method for Performance of Convection Ovens

F1521 Test Methods for Performance of Range Tops

F1605 Test Method for Performance of Double-Sided Griddles

F1639 Test Method for Performance of Combination Ovens

F1695 Test Method for Performance of Underfired Broilers

F1784 Test Method for Performance of a Pasta Cooker

F1785 Test Method for Performance of Steam Kettles

F1787 Test Method for Performance of Rotisserie Ovens

F1817 Test Method for Performance of Conveyor Ovens

F1964 Test Method for Performance of Pressure Fryers

F1965 Test Method for Performance of Deck Ovens

F1991 Test Method for Performance of Chinese (Wok) Ranges

F2093 Test Method for Performance of Rack Ovens

F2144 Test Method for Performance of Large Open Vat Fryers

F2237 Test Method for Performance of Upright Overfired Broilers

F2239 Test Method for Performance of Conveyor Broilers

F2474 Test Method for Heat Gain to Space Performance of Commercial Kitchen Ventilation/Appliance Systems

ASHRAE Standards

ANSI Standard

Keywords

capture and containment; commercial kitchen ventilation; exhaust airflow rates; hood performance; test method;

ICS Code

ICS Number Code 91.140.30 (Ventilation and air-conditioning systems); 97.040.99 (Other kitchen equipment)

DOI: 10.1520/F1704-12

ASTM International is a member of CrossRef.

ASTM F1704