ASTM F1750-05(2010)
Historical Standard: ASTM F1750-05(2010) Specification for Paintball Marker Threaded-Propellant Source Interface
SUPERSEDED (see Active link, below)
ASTM F1750
1. Scope
1.1 This specification covers the male and female threaded connectors used to interface a propellant source with a working pressure of 10 342 kPa (1800 psig) or less to a paintball marker.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D2240 Test Method for Rubber Property--Durometer Hardness
F2272 Specification for Paintball Markers
ANSI Standard
ANSIY14.5M19 Dimensioning and TolerancingCGA Standard
CGA-320 .825-14NGO-RH-EXT (Flat Nipple)Federal Standard
FED-STD-H28/9A 24 March 1989 Federal Standard Screw-Thread Standards for Federal Services Section 9 Gas Cylinder Valve Outlet and Inlet ThreadsMilitary Standard
MS28775 O-Ring Dash SizesKeywords
paintball marker; propellant; Consumer safety specifications (guns); Paintball sports--specifications; Guns; Propellants/projectiles (for guns); Sports equipment--specifications;
ICS Code
ICS Number Code 97.220.99 (Other sports equipment and facilities)
DOI: 10.1520/F1750-05R10
ASTM International is a member of CrossRef.
