1. Scope

1.1 This test method evaluates the energy consumption and cooking performance of large-vat open, deep fat fryers. The food service operator can use this evaluation to select a fryer and understand its energy efficiency and production capacity.

1.2 This test method is applicable to floor model gas and electric fryers with 50 lbs and greater fat capacity and an 18-in. and larger vat size.

1.3 The fryer can be evaluated with respect to the following (where applicable):

1.3.1 Energy input rate (10.2),

1.3.2 Preheat energy and time (10.4),

1.3.3 Idle energy rate (10.5),

1.3.4 Pilot energy rate (10.6, if applicable),

1.3.5 Cooking energy rate and efficiency (10.9), and

1.3.6 Production capacity and frying medium temperature recovery time (10.9).

1.4 This test method is not intended to answer all performance criteria in the evaluation and selection of a fryer, such as the significance of a high energy input design on maintenance of temperature within the cooking zone of the fryer.

1.5 The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D3588 Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels

ANSI Document

ASHRAE Document

Other Standards

Keywords

efficiency; energy; open deep fat fryer; performance; production capacity; test method; throughput; Cooking energy efficiency (CEE); Cooking/food service equipment performance; Energy analysis; Open deep-fat fryers; Preheat energy consumption/time; Production capacity; Throughput;

ICS Code

ICS Number Code 97.040.20 (Cooking ranges, working tables, ovens and similar appliances)

DOI: 10.1520/F2144-01E01

ASTM International is a member of CrossRef.