Abstract

This specification covers commercial powered pot, pan, and utensil washing sinks of the following types, styles, and classes: Type I, Type II, Style 1 (Class A and Class B), and Style 2, having the specified sizes for (1) drainboards, soiled and clean ends, (2) scrapper section, (3) wash sink, (4) rinse sink, and (5) sanitizer sink. The materials shall conform to the specified requirements and include: corrosion-resistant steel, corrosion-resisting material, nickel-copper alloy, and plastics. Construction requirements for the following are detailed: (1) piping, tubing, fittings, and valves, (2) spray assemblies, (3) tank, (4) overflow, (5) frame, (6) legs (feet), (7) pump and motor assemblies, and (8) heating. The electrical equipment requirements for the motors, controls, and wiring and circuit devices; lubrication requirements; and requirements for treatment and painting, are specified. Powered pot, pan, and utensil washing sinks shall conform to the specified performance requirements including noise level. Operational, leakage, and performance tests shall be performed.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers commercial powered pot, pan and utensil washing sinks.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

National Fire Protection Association Standards

ASTM Standards

A29/A29M Specification for Steel Bars, Carbon and Alloy, Hot-Wrought, General Requirements for

A120 Specification for Pipe, Steel, Black and Hot-Dipped Zinc-Coated (Galvanized) Welded and Seamless for Ordinary Uses; Replaced by A 53

A167 Specification for Stainless and Heat-Resisting Chromium-Nickel Steel Plate, Sheet, and Strip

A276 Specification for Stainless Steel Bars and Shapes

A436 Specification for Austenitic Gray Iron Castings

A554 Specification for Welded Stainless Steel Mechanical Tubing

A582/A582M Specification for Free-Machining Stainless Steel Bars

B43 Specification for Seamless Red Brass Pipe, Standard Sizes

B75 Specification for Seamless Copper Tube

B127 Specification for Nickel-Copper Alloy (UNS N04400) Plate, Sheet, and Strip

F760 Specification for Food Service Equipment Manuals

F2379 Test Method for Energy Performance of Powered Open Warewashing Sinks

National Electrical Manufacturers Association Standards

American National Standards

American Society of Sanitary Engineering Standards

Underwriters Laboratories Standards

NSF International Standards

Federal Regulations

Keywords

commercial; dishwasher; heater; pan; pot; powered; sink; utensil; Commercial dishwashers; Pan dishwashing machines; Sanitizing commercial dishwashing machines; Utensil dishwashing machines;

ICS Code

ICS Number Code 97.040.10 (Kitchen furniture)

DOI: 10.1520/F2643-09

ASTM International is a member of CrossRef.

ASTM F2643