1. Scope

1.1 This specification covers the chemical, mechanical, and dimensional requirements for roof and rock bolts and accessories. Addressed in this specification are double-end threaded and slotted steel bars; fully grouted bolts and threaded bars; mechanical anchorage devices used for point anchorage applications; roof truss systems; partially grouted deformed bolts; formable anchorage devices; and other frictional anchorage devices. All of these products represent various designs used for ground support systems. This specification can be revised to address new technologies.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This hazard statement applies only to Section 10, Test Methods of this specification. This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A29/A29M Specification for Steel Bars, Carbon and Alloy, Hot-Wrought, General Requirements for

A47/A47M Specification for Ferritic Malleable Iron Castings

A194/A194M Specification for Carbon and Alloy Steel Nuts for Bolts for High Pressure or High Temperature Service, or Both

A220/A220M Specification for Pearlitic Malleable Iron

A370 Test Methods and Definitions for Mechanical Testing of Steel Products

A416/A416M Specification for Steel Strand, Uncoated Seven-Wire for Prestressed Concrete

A536 Specification for Ductile Iron Castings

A563 Specification for Carbon and Alloy Steel Nuts

A615/A615M Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement

A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products

A882/A882M Specification for Filled Epoxy-Coated Seven-Wire Prestressing Steel Strand

A1011/A1011M Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High Strength

D1248 Specification for Polyethylene Plastics Extrusion Materials for Wire and Cable

D6637 Test Method for Determining Tensile Properties of Geogrids by the Single or Multi-Rib Tensile Method

F436 Specification for Hardened Steel Washers

F606 Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets

ASME Standards

Keywords

bolts, roof and rock and accessories; rock bolts; roof bolts;

ICS Code

ICS Number Code 21.060.10 (Bolts, screws, studs); 93.020 (Earth works. Excavations. Foundation construction. Underground works)

DOI: 10.1520/F0432-04

ASTM International is a member of CrossRef.